Spicer DS404 Reinforcing Instructions Manuel d'utilisateur télécharger pdf (Page 6)

17. Bracket Weld – Weld first pass, apply second or third passes as needed. When using a Mig Welder use approximate

setting of 30 volts and 180 amps. If using an Arc welder, use 1/8 inch, E7018 electrode.

Weld First Pass, Bottom of Bracket First Pass, Top Of Bracket

18. Clean and paint the repaired area.

Clean And Paint

19. Reinstall the torque rod, use same spacers.

Install Torque Rod Bracket

20. Reinstall inter axle driveline.

21. Reinstall tires and rims.

22.

Reconnect grounds and oil temperature wire.

If you have any questions about this procedure call the Spicer C

all Center at 1-800-621-8084.

1 2 3 4 5 6 7

Pas de commentaire

Spicer DS404 Reinforcing Instructions Manuel d'utilisateur Page 6